This is a completely 3D printed high quality 5.1 surround system, using drivers from Dayton Audio and Tang Band. Any capable AV Receiver will be able to drive this system, however you do not need very much amplifier power, which means that even a good budget AV receiver will be more than suitable. The subwoofer can easily go down to 35Hz, and will provide ample bass output for a small to medium sized room.
Get the BUILD PLAN here: https://bit.ly/3SilozG
Parts Lists:
- Speaker wire (14 AWG) – (US) https://bit.ly/2BuKbLc , (EU) https://bit.ly/39erRI4
- Tang Band W6-1139SIF 6-1/2″ Paper Cone Subwoofer – (US) https://bit.ly/3SvdsuC , (EU) https://bit.ly/3RfDlND
- Dayton Audio DMA58-8 2″ Dual Magnet Aluminium Cone Full-Range Driver 8 Ohm – (US) https://bit.ly/3SthsM4 , (EU) https://bit.ly/3r9U6PG
- Lepai LP210PA 2.1 Plate Amplifier with Power Supply – (US) https://bit.ly/3LAupkY , (EU) https://bit.ly/3BC5WXQ , https://bit.ly/3Rab6jA
- Speaker Binding Posts – (US) https://amzn.to/3BFct4b
- PLA Matte Filament 1.75mm 1Kg – (US) https://amzn.to/3C3nQEb , https://amzn.to/3dIXzSh
- #6 x 3/4″ (3.3 x 19 mm) Deep Thread Pan Head Screws Black – (US) https://bit.ly/2Gvk8XM , (EU) https://bit.ly/3maZwqC
- Polyester Batting – https://amzn.to/3xAhj17
- 6mm x 3mm (1/4 inch wide, 1/8 inch thick) Self Adhesive Weather Stripping – https://amzn.to/3u1N0vF
- 20mm or 3.4inch Stick-on felt feet – https://amzn.to/3feVCxg
- Rubber Stick-on feet – https://amzn.to/3dy5Vwd
- CA Glue – https://amzn.to/3DQkqGs
- Construction Adhesive or 2-Part Epoxy Glue – https://amzn.to/3C6faNE , https://amzn.to/3C3rE8p
- Drill – https://amzn.to/3fcZgIa , https://amzn.to/3Uz1W35
- Drill Bits – http://amzn.to/2hOSS8O
- Hot glue gun – https://amzn.to/3C3cr7r
- Screwdrivers – https://amzn.to/3Racm6i
- Orbital sander with 240 grit sandpaper – http://amzn.to/2zljy7Y , https://amzn.to/3LJhcGG
- Wire Snips – http://amzn.to/2zkGh44
- Soldering Iron and Solder – http://amzn.to/2yydWd2
- Utility Knife – https://amzn.to/3dHROEy
